This message occurs when you try to open a report that was created with a different version program table than what you have tagged in QR's Options | Install Data area.

The other instance is when you do not have any tables for this product tagged.

Go into QR Designer. Select Options | Install Data. Look for the QI table description that matches the version of QIP you are using. For example, if you are using QIP6.5A, look for that description. The actual version of the QIP tables have not changed - the far right version will still show "QI 6.2A" as the Version description, even though you have V6.5A or higher installed.

If the table does not have a little arrow beside it, it has become "un" selected due to the moving around of your programs and data.

Re-installing QIP was a good idea, however, make sure you installed it to the correct location (in your case, on the Server's hard drive). Be aware that the programs and data may not reside on the same drive. The data only may be on the P:\ drive, while the programs may (for example) reside on O:\. Also, when you are installing programs onto a Server, you may need proper network rights to do so. Check with your network or system administrator if you are not sure about this.

In order for Quik Reports to successfully report on QIP data, QIP must be installed AFTER QR. If QR gets reinstalled, so must QIP. In this case, both the qi*.* and the qr*.* files must be in the same data directory along with any other applications' datafiles that you have in your report.

Also check that the Windowing System Manager Start List entries for both your QIP and QR are pointing to the correct location of the data now.

Hope this helps. If you are still experiencing problems, please feel free to submit another post.

Regards,