Hi CLS,

When an order is entered and an item added to an order, the picking sequence for the item at the desired location is written to the order. It is this value that prints on picking slip specifications, using the D17 spec code.

If you edit the item in inventory and change the picking sequence, this will not retroactively adjust all outstanding orders to the new value. New orders will use the new picking sequences, but existing orders will remain as they are. This is why it was suggested to you to edit the order and re-save all items.

Make sure that you have edited the picking sequence in the correct places on the inventory items. Because you can store different pick sequences by location, it is possible to update the master item but not change the pick sequence for particular locations. Edit the Item and go to the Location tab. You can see the defined Pick Sequence for each of your locations - where a value of 'Default' means to read the master item value, and something other than 'Default' means a specific value has been defined for the location.