Hi Franky

I'm not sure what you are doing with this statement:

"Install all modules workstation setup for station B. Find the G/L and A/P. move all data from Station B's C drive to G network drive."

I hope you didn't do a full install from station B. Only a workstation install is necessary.

I am sure you should not have done a workstation install on Station A - you don't need to perform a workstation install from the station where the full install was performed. That's why all of the menu options were greyed out when you tried.

If I were you, I would start all over again, following proper procedures. Rename the \Softrak folder to \SoftrakOld, and begin from scratch.

Steve